How can I enroll the admin's fingerprint on the FC 100 clock?

These instructions will guide you through enrolling an admin with a fingerprint on the clock. Admin access is required to complete the steps. This process enables administrators to clock in and out using their fingerprints instead of a card or password.

To enroll an administrator's fingerprint on the clock, follow these steps:

1. Go to My Employees >> Employee Setup >> Edit the employee's profile.
2. Locate Hardware Settings.
   
   
   
   
3. Enter Clock User Id and set Security Level to Administrator.
   • Clock User Id can be up to 9 digits.
   • This field must be set before finger enrollment on the time clock.
4. Save your changes.
5. Make note of the Clock User Id.
6. Go to Company Setup >> Time Clocks >> verify that the status is green.
7. Go to Company Setup >> Time Clocks >> Assigned Employees.
8. Make sure there is a check next to the employee(s) names.
9. Click Done when finished.
10. Take the administrator to the FC 100 Time Clock.
    
    
    
    
11. Press MENU.
12. Select Register, press OK.
13. Select Admin, press OK.
14. Select New Reg, press OK.
    • If the admin already has a password or badge in the software and has been assigned to the clock, select Backup instead of New Reg.
15. Select Finger, press OK.
16. Using the keypad, enter the admin’s Clock User ID defined in ProPunch and press OK.
17. The user will be prompted to take 3 samples of the same finger.
18. If the 3 scans are successful, the clock will prompt to continue.
19. Press OK to enroll a second (backup) finger for the same admin or press ESC to repeat the enrollment steps for the next admin.
20. Once complete, press ESC until the Welcome screen appears.
21. Have the admin complete a test punch and check the software to ensure that it has been registered.